Najnowsze z galerii

1 post
bat44
Starszy marynarz
1 / 3
RAF Crash Tender
here's some pic's of my fire boat, it's taken me about 18 months to get it to look like this, not happy with the air vents on top of the boat but have got hold of some of the original vents, so will be taking a mould of these and then I will put them on the boat, then I can start the painting
Polubione przez circle43nautical
7 komentarzs
  • bat44Starszy marynarz
    well got round and moulded some proper cowl vents for my fire boat.they look a lot better then the graupner vents
  • LyleStarszy bosman 2 klasy
    Hello all you Fire Boat restorers, I carefully noted the rather belled style of the vents as less streamlined as compared to the bought ones and when the vent front edge is carefully sanded flush, I found suitably thickened in section, silicone "O rings" from my big box of multiple o rings pack as sold by car part and engineering shops. A small piece of plasticine was used to hold the rings in place and super glued to affix.With care the small dab of holding plasticine was uppermost to not stick as the glue ran around down due to gravity. When a few hours later the usual re paint of the modified vent was done,the paint adhered. I Oz I have to run in salt water at the lake entrance and no effects at all ( obviously). I love my I/c Fire boat ( some 34 /39 years or so) with its third engine now and I still cannot help myself as I did hinges for the rear hatch roof to now open. All the best for detailers. When Peter Dimberline stayed with us some years back he ran it at ballistic speed, which shocked me as I run it just up un the plane. (Secret) you can cheat and add an extra wide strip along the chine up to almost an additional 1/8 inch extra wide without visual loss to the lines of the vessel to help her get up and stay in a hard chop as mine is the 46 inch version and some 18 to 20 pounds in weight, so perhaps the smaller 34 inch version and electric may benefit from this idea as the smaller versions tend not to sit too well and seem too far out of the water exposing too much of the f'd keel for some reason? I really enjoy all the Fire Boat resurgence of you guys. Lyle.
  • LyleStarszy bosman 2 klasy
    Hi, I was so surprised at your having some printed pictures and two reference pages of the Fire Boat ? is a set of emailed copies of the two reference pages displayed on the right hand side of your picture available to be sent my email if your are inclined, please ? (I can forward my address for email) Certainly very nice to have . Regards Lyle.

Polubione przez

Ładowanie…

Delete this post?

Zostanie usunięte z serwisu.

Odrzucić tę wersję roboczą?

Twój szkic zostanie usunięty i nie można go odzyskać.

Masz niedokończony szkic

Co chcesz z tym zrobić?