MODEL BOATS WEBSITE

Model Łodzie Strona internetowa

Zaloguj lub zarejestruj się, to darmowe!

United States

Zaloguj lub zarejestruj się

Moje konto

Informacje o serwisie

Anteo 2

Autor davecox3 1 zgłoszenie 6 maj 2017

0Polubienia

5Komentarze

0 obserwujący

Rozdział 01 / 01

Rozdziały · 1 · przewiń, aby przeczytać

davecox3 Post otwierający 10 lat temu

Anteo 2

😎I have just begun building this tug from a wooden kit and will keep everyone updated as the build goes

5 komentarzs

RNinMunich Bronze
Admirał floty10 lat temu
Hmm! Looking closer I don't see any shaping of the outboard edges of the bulkheads!? 😲
This is essential to do before planking to ensure proper seating (greater glue contact area) of the planks and maintaining the correct hull shape.
Use a medium grade sandpaper wrapped around a block of wood ca 2 x 1 and at least as long as the length along 3 adjacent bulkheads.
If I've missed some detail please ignore the ramblings of an old man, if not ....! Cheers Doug 😎
Lubię to
RNinMunich Bronze
Admirał floty10 lat temu
Looking very good 👍
I see you have the keel clamped in a vice. Good, but one at each end might have been better!? Should limit/stop any tendency of the structure to twist. Don't release it until glue on the final planks is set!
Otherwise normal practise to prevent twist is to plank upside-down (as Dave said) fixed to the building board, starting at the keel and working up on alternate sides. Looking forward to progress reports. 😎
Lubię to

Zaloguj się to comment on this update.