Komentarze

Zaloguj się skomentować.

1. ads90🇬🇧

   Sierżant sztabowy·6 lat temu

   Thanks Martin. I see the smallest width is still 10mm which would mean cutting it down to size along the length which is feasible with a scalpel and steel straight edge. Cheers Alan

   Polubione przez Martin555
2. Martin555🇬🇧

   Admirał floty·6 lat temu

   Hi ads90,
   Maybe something like this ?
   If you type in "self adhesive thin rubber strip" into Ebay there is quite a selection.
   
   https://www.ebay.co.uk/itm/SOLID-NEOPRENE-RUBBER-STRIP-SELF-ADHESIVE-various-Widths-and-Thicknesses/182642824090?hash=item2a865c539a:g:4UAAAOSwq~tZVLS~
   
   Martin555.

   Polubione przez ads90
3. ads90🇬🇧

   Sierżant sztabowy·6 lat temu

   Thanks Nerys and Martin for the comments. Any suggestions regarding the waterproofing between the hull and the deck ? As you may know, the whole of the deck is fixed to the hull by 7 screws - there is no recess to insert a seal between both parts but wondered if there may be a thin rubber strip about 3mm by 2mm that has an adhesive backing on one side only that might be used ? I need access to the internals through the hull although I have made a small removable access to enable the BEC supply via a switch to the receiver and possibly a battery charging point.

   Polubione przez Martin555
4. Martin555🇬🇧

   Admirał floty·6 lat temu

   Nice work ads90
   
   Martin555.

   Polubione przez stevedownunder
5. Nerys🇬🇧

   Admirał floty·6 lat temu

   Always very satisfying to restore a boat donated to under such conditions, especially when you make such a good job of the restoration.
   
   Cheers, Nerys

   Polubione przez jsps1 and Ronald and 3 others